The Climb From Water ability allows the character to climb out of the water onto a horizontal platform. The ability will detect the climbing object set by the inherited Detect Object Ability Base ability.

Climb From Water is a transition out of Swim, not a general mantle. It searches for an eligible edge from the swimming pose, rejects water that is too deep for the supported move, aligns to Climb Offset, and moves the character to the exit pose before normal locomotion resumes.

Setup

Position Climb From Water above the Swim ability so it can take control of the exit transition.

Key settings

Inspector field Purpose
Max Water Depth The maximum water depth that the character can climb from.
Climb Offset The offset that the character should start climbing from.
Move To Position Speed The speed that the character should move towards the target when getting into position.

Author a climb-out edge

The platform needs a detectable face, a horizontal landing surface, and enough clearance for the character collider and climb animation. Exclude ladders, steep banks, and decorative lip colliders unless they are intentionally supported exits. Keep the water volume active until the ability has taken control; ending the volume too far from the ledge can stop Swim before the exit is available.

Max Water Depth limits the vertical relationship from which the transition can start. Use it to prevent an implausible climb from deep below the ledge. Climb Offset defines the animation-ready pose relative to the detected edge, and Move To Position Speed controls convergence to that pose.

Tune the offset at low speed first, then test while approaching diagonally and while the surface is moving. If the character snaps, slow the convergence or move the target pose closer to the current swim pose. If the ability never starts, verify the detection filter, water depth, platform clearance, and that Climb From Water has priority over Swim.